2004 TL – Audio-HVAC Display Module Assembly Removal/Installation SRS components are located in this area Review the SRS component locations, and the precautions and procedures before performing repairs or service. NOTE: – Put on gloves to protect your hands. – Take care not to scratch the dashbord and related parts. – Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage. 1.Make sure you have the anti-theft codes for the radio and navigation system, then write down the channels for the XM radio’s presets. 2.Remove the center console rear section and center console panel. 3.Remove the upper panel. 4.Remove the screws and bolts, then pull out the audio-HVAC display module assembly (A). 5.Disconnect the connectors (B) and antenna lead (C), then remove the audio-HVAC display module assembly. 6.Install the audio-HVAC display module assembly in the reverse order of removal, and note these items: – Make sure all connectors and antenna lead are secure. – Enter the anti-theft code for the radio, then enter the customer’s XM radio channel presets, and set the clock. – If necessary, enter the navigation system anti-theft code.
Recent Searchthermostat housing for 2000 lincoln ls - 98 cadillac eldorado heater core replacement - how to set timing on 2004 kia sorento - audi q7 battery codes list - 2006 honda civic engine oil leak above power steering pump? - what size bolt torsion key hummer h3 - 2000 honda accord ex ball joints - how to completely replace belt x5 - 1992 bmw 325i wiper motor - how to do a body lift on a buick lesabre 2001 -